Wax print cami

Wax print cami

I have this bright floral cami/tank top (is there officially a difference here? I tend to use them interchangeably) that I bought on a whim when I was heavily pregnant and too big to fit into it, just because I liked the colours. Months later when I was able to try it on, I realised I really liked the relaxed, slightly boxy fit of it, and I’ve worn it loads since.

So when my mum gave me the remnants of a lovely bright wax print cotton and I knew I wanted to make a summer top from the pieces that were left, I figured I’d try to clone that RTW cami. And guess what, it turned out pretty well! I knew the cotton would look more stiff than the drapey original but figured it would still have a nice shape with lots of room for the “food baby” situation I can get after a big meal. Two kids = no abdominal muscle strength. I’ve come to accept it.

I started by making bias tape for the neckline and straps. I’d read about two ways of doing this, over the last few months, but never actually bothered to try either. So, in the spirit of #memademay2016 I decided to take the plunge and start with what looks like the more fiddly method. I cut 1″strips on the bias..

.. Squared off the edges, joined them up with a diagonal seam, ironed the resulting long strip (with starch spray!) fed them into a bias tape gadget thingy and pressed. And hey “press-to”(presto! … I apologise.) 1/4” bias tape!


diy bias binding tape

I think I got just over 3m from three randomly sized scraps of fabric. I worked out that I’d need about 1.2m so I’ll have some left over to beautify another project. And I still have more scraps of this fabric so no doubt I’ll turn those into bias tape too.

(Aside: and now I know what to do with the scraps I’ve collected from projects so far that looked too big to throw away. You know, like when you buy fabric online and you have to buy 2m even though you only need 1.7? Grr! Bias tape and pocket linings, methinks..)

Back to the construction of the top.. I traced out a pattern for the front and back pieces, directly from the RTW top. Because of the fabric pieces I was working with, I had to introduce seams at the center front and back rather than cutting on the fold. I also couldn’t do any pattern matching, which is a shame, but the print is so busy that I don’t think that matters *too* much.

The pattern pieces looked like this, without the straps and before the side seams were sewn:

And then I did a bias binding on front and back neckline curves, leaving a little bias tape out beyond the neckline at each end:

Before finally going round each semi-armscye curve and then forming a big loop, with the bias tape, to form the straps:

The insides are pretty neat, with French seams, a care label and my memade label.

I made this in about three hours between 2am and 5am this morning,  while everyone else was asleep. So you’ll have to excuse the quality of the pics below and the fact that I’m not showing my bleary-eyed face, since I took them when Baby Boy woke up fully rested at 6am an hour after I’d gone back to bed.


Hopefully the sun will come out today so I can update this post with nicer pics. I might have promised my nearly-three year old yesterday that we would go to the park today and I have a feeling he’s going to hold me to it, so please, London – give us some sunshine!
– Michelle –

Back to blog

Leave a comment

Please note, comments need to be approved before they are published.